UNDERCOVER LIGHTS INSTALLATION INSTRUCTIONS;
PRODUCT WARNING; WARRANTY INFORMATION
Undercover Lights—Trailer Auxiliary Lighting Kit
Warning and Important Safety Reminder
To properly and safely install Undercover Lights, it is important to read and thoroughly
understand the instructions, including all diagrams and/or pictures.
Do not install the product in hazardous conditions or situations.
Read the owner’s manual of the vehicle and/or trailer in which the product is being
installed and investigate the local and any other applicable traffic rules to determine
whether there are any restrictions or warnings on or regarding the use of this auxiliary
light which may impact your use. It is the owner’s responsibility to investigate these
These instructions are intended to assist with easy installation and to help you avoid
injury. Stratus Industries and its affiliates and related entities are not liable for any
injury or damages caused by improper installation or improper use of the product.
Failure to follow these instructions and all related safety precautions set forth in this
document may result in property damage, serious injury or death.
NO WARRANTIES, EXPRESS OR IMPLIED, REPRESENTATIONS,
UNDERSTANDINGS, GUARANTIES OR PROMISES HAVE BEEN MADE TO OR
RELIED UPON BY BUYER IN MAKING THE DERMINATION TO PURCHASE
THE PRODUCT, AND TO THE EXTENT PERMITTED BY THE LAW, ALL
WARRANTIES, INCLUDING THE IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE
EXPRESSLY DISCLAIMED HEREIN. Regarding any implied warranties that cannot be
disclaimed in whole or in part, incidental and consequential damages are disclaimed.
Installation Tools: Wire cutters/crimper; Wire strippers; Clean cloth; Household degreaser.
Installation of LED PODS
Clean the area thoroughly with a household degreaser, wipe the area with alcohol pad included in the kit,
and then dry it with a clean towel. Peel the paper off of the double faced tape on the LED POD and apply the POD. Stretch the wire out and
apply the next POD. Continue this process and apply all of the PODs.
Reapply pressure to each POD for proper adhesion.
Follow the same procedure for all LED POD’s.
Installation of POD Light Wire
Route 20 foot POD light wire from the switch/switch location to the first strand of POD lights.
Cut excess wire so that you can use it to connect the first string of POD’s to the second string of pods.
Make sure the route chosen does not obstruct with the trailers normal functions.
Use the butt connectors to connect the wire to POD light strand. Note: White is positive. Connect the
wire as shown in the diagram.
Installation of Switch
Select a mounting location for switch. Mount the switch so that it is easily accessed.
Clean area where the switch will be mounted with a household degreaser. Then wipe that area with the
alcohol pad supplied with the kit, dry it with a clean towel.
Peel the paper off the tape and mount the switch.
Use tyrap base to secure switch wire, as is necessary.
Connect switch wire as shown in the wire diagram, below. The positive of the battery is connected to the
positive of the switch.
Connect the negative wire from both sides of lights with the yellow butt connector, to the negative of the
Installation of Fuse Link
Crimp fuse link assembly to Main Line and connect ring terminal to Positive side of battery.
Crimp butt connector to Main Line and Connect to Negative side of battery.
Make sure all connections are secure and all bare wires are covered before proceeding any further.
Insert 10 amp fuse, Install 8 AA battery’s into battery box and turn on the switch to test.
To troubleshoot, inspect the system in the following order: Wire connections; battery connections; switch
connection; and finally, LED pod connections.